Back Seat Heat Shield for RZR

$189.95$213.95

-

Orders outside of the United States will require an up charge of $70.00 paid after order is  received. .   Duty and taxes will be paid  by the receiver.  Please call for any additional  questions.  Shipping to Australia will require an additional $180.00.

 

Your heat shield will ship Ground Service, with in the United States, due to the size and weight.  For expedited shipping please call 770 598 2994 

Description

This is our solution. Its a aluminum foil insulating sound proofing material that we heat laminated to a rubber backing with mylar bubble insulation in between for great insulating ability.  It is then die cut, seemed to be a fitted to the full back panel, to not only to insulate but stop the hot air that is pulled in from the back when you are running full wind shields.  Not only does it block the back heat out it greatly reduces engine noise in the cab. You can take it out in the winter to get your heater back. If you use harnesses we also offer rubber harness grommets to close off the heater vents were the harnesses attach. They also give a finished look.

                                                                       Directions For Use

Remove the two seats. Slide one side of the mat under the seat belt or harnesses, keeping the end rolled inward, then do the same to the other side.  Line the center up and slide the mat down, while bending the bottom of both sides, forward, under where the seats go.  The center bottom should fit down between the back firewall and the drive line cover. The mat should cover around 5 inches under the seats (when installed) Then fit the sides around the frame and seat belt brackets.  Press the mat, to fit it to the firewall. Pull back the top corners of the mat, to see where the Velcro will attach. Clean the area of the firewall, where the Velcro will attach. Leaving both sides of the Velcro attached to the mat, peal the Velcro dot backing and heat with a blow dryer.  Once warm, push the corners back to the firewall, pressing to ensure the Velcro dot adheres to the plastic.   If you have a back-window panel, the mat should be under the panel seal.   If you are using stock seat belts you will need to cut the mat on the dotted lines before installation.

PLEASE TAKE A FEW MOMENTS TO READ OUR REVIEWS

Our reviews are as unique to online sale as our products are to the TENS of thousands of users.
They are from online community customers all over the web so you know they are real.

https://www.rzrforums.net/rzr-xp-1000-rock-trail-l-e-forum/524498-wolfsnout-cooler-package.html

These are AMAZING!!! I wont ride without a set ever again. One of the best fitting goggles I’ve had and the mask is soo comfortable you can barely even tell its there!!
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/wolfsnout/181233-dust-goggle-mask-set-up.html#post2183587

I received my shipment late last week… Decided to try them out this weekend while out riding on some extremely dusty trails, these are awesome!!!
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/wolfsnout/62407-wolfsnout-dust-mask-17.html#post1336755

Tim is a great guy! I have enjoyed my dealings with him also.
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/general-rzr-discussion/201626-tim-wolfsnout.html#post2409138

Every dealing I’ve had with Tim has been positive, and I’ve had a few. Great product, great guy!
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/general-rzr-discussion/201626-tim-wolfsnout.html#post2410194

Ok, I thought it best that I check back in and tell you how I liked the goggles. Rode with them yesterday. The best I’ve ever worn. I wear glasses and with my Oakleys they fog up when I ride. Not so with the Premium goggles.
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/general-rzr-discussion/155188-thanks-tim-wolfsnout.html#post1882290

Hey Tim
Thanks again for the mask, (The Best Mask I Have Ever Used)
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/wolfsnout/182492-thank-you-wolfsnout.html#post2195069

LOVE MINE! BEST THING SINCE SLICED BREAD! GET YOU SOME! My only suggestion is get some extras and sell them to your buddies when the dust flies and they want one!!
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/general-rzr-discussion/91230-review-wolf-snout-2.html#post1138454

I will also add the Wolf Snout is excellent for customer service!!
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/general-rzr-discussion/91230-review-wolf-snout-2.html#post1138456

these are VERY effective products. I, along with a couple of my friends, have been using these for the past couple of years and we all happy with them.
VALIDATE THIS REVIEW HERE:
http://www.rzrforums.net/general-rzr-discussion/91230-review-wolf-snout.html#post1128823

Reviews

There are no reviews yet.

Be the first to review “Back Seat Heat Shield for RZR”

Your email address will not be published. Required fields are marked *